Cabling Pinouts - HP AA979A - StorageWorks SAN Switch 2/8V Installation Manual

Table 32 describes the cable pinouts.
Table 32

Cabling pinouts

Pin Signal
1 Not supported
2 RxData
3 TxData
4 Not supported
5 GND
6 Not supported
7 Not supported
8 Not supported
9 Not supported
A 10-foot (3.0-m) serial cable is provided with the switch. It can be converted from a DB–9
serial cable to an RJ–45 serial cable by removing the adapter on the end of the cable.
To remove the adapter from the end of the DB–9 serial cable:
1. Ensure the cable and both screws have been disengaged.
2.
Pull the adapter straight out, without moving it from side to side, to loosen seating of the
connector. If you move the adapter side to side, you might damage the it.
CAUTION:
excessive force; otherwise the DB–9 connector will split into two parts easily so that the
switch's DTE port is not damaged.
108 SAN Switch technical specifications
Description
Not supported
Receive data
Transmit data
Not supported
Logic ground
Not supported
Not supported
Not supported
Not supported
When removing the DB–9 male connector from the DTE port, do not use