Number Of Screws Required To Assemble The Inner Rails - HP AA979A - StorageWorks SAN Switch 2/8V Installation Manual

Table 8

Number of screws required to assemble the inner rails

Switch
SAN Switch 2/8V
SAN Switch 2/16V,
SAN Switch 2/16N
SAN Switch 4/32
6. Identify the screw holes on the inner rails for your specific switch. The screw holes are
labelled as follows:
a. To attach the inner rails to the SAN Switch 2/8V, SAN Switch 2/16V or
SAN Switch 2/16N use the screw holes marked 8.
b. To attach the inner rails to the SAN Switch 4/32 use the screw holes marked 16.
NOTE: The mounting holes in the inner rails are marked 32, 16, and 8. For the SAN Switch
2/8V, SAN Switch 2/16V or SAN Switch 2/16N use the screw holes labelled 8. For the SAN
Switch 4/32, use the mounting holes labelled 16.
7. Secure the two inner rails (one on each side) of the switch using the appropriate number of
screws (refer to Table
• For the SAN Switch 2/8V, secure each inner rail (one on each side) to the switch using
five #8-32 x 5/16-inch Phillips pan-head SEMS screws as shown in
• For the SAN Switch 2/16V or 2/16N, secure each inner rail (one on each side) to the
switch using five #8-32 x 5/16-inch Phillips pan-head SEMS screws, see
• For the SAN Switch 4/32, secure each inner rail (one on each side) to the switch using
five #8-32 x 3/16-inch Phillips pan-head screws with thread lock as shown in
Figure 14.
NOTE:
For factory integration only, tighten the #8-32 x 5/16-inch Phillips pan-head SEMS
screws and torque between 6 to 8 inch-pounds.
#8-32 x 5/16-inch screws
10
10
Not Applicable
8) as follows:
SAN Switch 2/8V, 2/16V, 2/16N and 4/32 installation guide
#8-32 x 3/16-inch screws
Not Applicable
Not Applicable
10
Figure 12.
Figure 13.
45