HP AA979A - StorageWorks SAN Switch 2/8V Installation Manual page 84

CAUTION:
sure that it is correctly oriented before continuing.
c. Secure the power supply to the chassis by tightening the captive screw using the
Phillips-head screwdriver.
7.
Plug the power cord into the power supply and press the AC power switch to turn it on.
8. Verify that the LED on the new power supply displays a steady green light while the switch
is operating (see
installed.
9.
Optional step: issue the psShow command at the CLI prompt to display power supply
status. Fabric OS identifies the power supplies in a SAN Switch 4/32 from left to right as
PS2 and PS1,as shown in
84 Installing field-replaceable units
Do not force the installation. If the power supply does not slide in easily, make
Table 21). If the LED is not green, ensure that the power supply is firmly
Figure 25.