Management Ethernet Port Led; Power Supply Status Led; Rps Status Led - HP FlexNetwork 5140 EI Series Installation Manual

Table 26 System status LED description
LED mark
SYS

Management Ethernet port LED

Table 27 Management Ethernet port LED description
LED mark
LINK/ACT

Power supply status LED

The HPE 5140 24G SFP w/8G Combo 4SFP+ EI switches provide PWR1 and PWR2 LEDs on the
front panel to indicate the operating status of the power supplies.
Table 28 Power supply status LED description
LED mark
PWR1/PWR2

RPS status LED

The HPE 5140 24G PoE+ 4SFP+ EI and HPE 5140 48G PoE+ 4SFP+ EI switches support RPS
input and each provide an RPS status LED on the front panel to indicate the RPS operating status.
Table 29 RPS status LED description
LED mark
RPS
Status
Steady yellow
Steady green
Flashing green (1 Hz)
Flashing red (3 Hz)
Off
Status Description
Steady green A link is present on the port.
Flashing green The port is sending or receiving data.
Off No link is present on the port.
Status Description
A power supply is installed in the power supply slot, and the
Steady green
power supply is outputting power correctly.
A power supply is installed in the power supply slot, but the
Steady yellow
power supply is faulty or not powered on.
Off No power supply is installed in the power supply slot.
Status Description
Steady green Both the RPS DC input and the AC input are normal.
The RPS DC input is normal, but the AC input is disconnected or
Steady yellow
has failed.
Off The RPS DC input has failed, or no RPS is connected.
Description
Boot ROM booting stage.
Linux kernel booting stage, or the switch has started up
correctly.
Software image loading and decompressing stage, or
software booting stage.
The switch has failed POST or the switch is faulty.
The switch is powered off or has not started up correctly.
56