Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual page 263

trapRegFilter 1.3.6.1.3.94.2.3.1.3
This value defines the trap severity filter for this trap host. The connUnit sends traps to this host
that have a severity level less than or equal to this value. The default value of this object is Warning.
The mapping between errorlog severity level and this variable is:
TABLE 22
System Error Log
errshow command
none (0)
Critical (1)
Error (2)
Warning (3)
Info (4)
Debug (5)
This severity applies to all entries. See
The values 1, 3, 7, and 10 are not valid for SET operations.
trapRegRowState 1.3.6.1.3.94.2.3.1.4
Specifies the state of the row. This entry always returns rowActive and allows for read-only.
TABLE 23
State
rowDestroy (1)
rowInactive (2)
rowActive (3)
Fabric OS MIB Reference
53-1000602-01
FA-MIB
unknown (1)
critical (4)
error (5)
warning (6)
info (8)
debug (9)
TrapRegRowState for Read/Write
Description (Read)
Read: Can never happen.
Read: Indicates that this row does
exist but that traps are not enabled
to be sent to the target.
Read: Indicates that this row exists
and that traps are enabled to be sent
to the target.
trapRegFilter 1.3.6.1.3.94.2.3.1.3
Table 20
FcEventSeverity in
Description (Write)
Write: Remove this row from the table.
Write: If the row does not exist and the agent allows
writes to the trap table, then a new row is created. The
values of the optional columns are set to default
values. Traps are not enabled to be sent to the target.
If the row already existed, then traps are disabled from
being sent to the target.
Write: If the row does not exist and the agent allows
writes to the trap table, then a new row is created. The
values of the optional columns are set to default
values. Traps are enabled to be sent to the target. If
the row already exists, then traps are enabled to be
sent to the target.
on page 205.
8
245