Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual page 167

swAgtCmtyStr 1.3.6.1.4.1.1588.2.1.1.1.4.11.1.2
This is a community string supported by the agent. If a new value is set successfully, it takes effect
immediately.
Default values for communities are as follows:
•
•
•
•
•
•
Community strings 1-3 are read-write and strings 4-6 are read-only.
You can change the community setting using the snmpconfig command.
swAgtTrapRcp 1.3.6.1.4.1.1588.2.1.1.1.4.11.1.3
This is the trap recipient associated with the community. If a new value is set successfully, it takes
effect immediately.
If not otherwise set, the default IP address for this trap recipient is 0.0.0.0 and the SNMP trap is
not sent for the associated community string.
With a setting of non-0.0.0.0 IP address, SNMP traps are sent to the host with the associated
community string.
Any or all of the trap recipients can be configured to send a trap for the associated community
string. The maximum number of trap recipients that can be configured is six. If no trap recipient is
configured, no traps are sent.
The trap recipient IP address should be part of the Access Control List for Fabric OS v2.6.1, v3.1,
and v4.x (See the Fabric OS Command Reference and the snmpConfig command for more
information).
swAgtTrapSeverityLevel 1.3.6.1.4.1.1588.2.1.1.1.4.11.1.4
This is the trap severity level associated with
trap severity level, is in conjunction with the event's severity level. When an event occurs, and if its
severity level is at or below the set value, the SNMP trap is sent to configure trap recipients. The
severity level is limited to particular events. If a new value is set successfully, it takes effect
immediately.
This object obsoletes
Fabric OS MIB Reference
53-1000602-01
1 (Secret Code)
2 (OrigEquipMfr)
3 (private)
4 (public)
5 (common)
6 (FibreChannel)
swEventTrapLevel
swAgtCmtyStr 1.3.6.1.4.1.1588.2.1.1.1.4.11.1.2
swAgtTrapRcp 1.3.6.1.4.1.1588.2.1.1.1.4.11.1.3. The
1.3.6.1.4.1.1588.2.1.1.1.8.1.
5
149