Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual page 242

8
connUnitPortControl 1.3.6.1.3.94.1.10.1.16
•
•
•
•
224
bypassConnUnitPort
If the addressed connUnit allows this operation to be performed to this port, the addressed
port performs a vendor-specific "bypass" operation.
Examples of these operations are:
-
Transitioning from online to offline.
-
A request (NON-PARTICIPATING) command to the loop port state machine.
-
Removal of the port from an arbitrated loop by a hub.
unbypassConnUnitPort
If the addressed connUnit allows this operation to be performed to this port, the addressed
port performs a vendor-specific "unbypass" operation. Examples of these operations are
-
The Link Failure protocol.
-
A request (PARTICIPATING) command to the loop port state machine.
-
Addition of the port to an arbitrated loop by a hub.
offlineConnUnitPort
If the addressed connUnit allows this operation to be performed to this port, the addressed
port performs a vendor-specific offline operation.
Examples of these operations are:
-
Disabling a port's transceiver.
-
The Link Failure protocol.
-
Request (NON-PARTICIPATING) command to the loop port state machine removal of the
port from an arbitrated loop by a hub.
onlineConnUnitPort
If the addressed connUnit allows this operation to be performed to this port, the addressed
port performs a vendor-specific online operation.
Examples of these operations are:
-
Enabling a port's transceiver.
-
The Link Failure protocol, request (PARTICIPATING) command to the loop port state
machine.
-
Addition of the port from an arbitrated loop by a hub.
Each implementation might choose not to allow any or all of these values on a SET.
If the management station uses in-band communication (FC-IP) with the switch, either of
the two following actions might result in a loss of in-band communication with the switch:
•
Disabling the FC port that is connected to the management station
•
Disabling the embedded port
Fabric OS MIB Reference
53-1000602-01