Switch And Platform-Class Platform Shutdown - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

5. To verify the audit event log setup, make a change affecting an enabled event class, and confirm that
the remote host machine receives the audit event messages.
The following example shows the SYSLOG (system message log) output for audit logging.
Jun 2 08:33:04 [10.32.220.7.2.2] raslogd: AUDIT, 2006/06/02-15:25:53,
[SULB-1003], INFO, FIRMWARE, root/root/NONE/console/CLI, ad_0/ras007_chassis, ,
Firmwarecommit has started.
Jun 5 06:45:33 [10.32.220.70.2.2] raslogd: AUDIT, 2006/06/05-13:38:17,
[CONF-1010], INFO, CONFIGURATION, root/root/NONE/
console/CLI, ad_0/ras070, , configDownload failed
Jun 5 08:15:32 [10.32.248.73.2.2] raslogd: AUDIT, 2006/06/05-13:38:17,
[SEC-1000], WARNING, SECURITY, JaneDoe/root/192.168.132.19/
telnet, Domain A/DoeSwitch, , Incorrect password during login attempt.

Switch and platform-class platform shutdown

To avoid corrupting your file system, HP recommends that you perform graceful shutdowns of switches and
Directors. The following procedure describes how to gracefully shut down a switch.
To power off a switch:
1. Connect to the switch and log in using an account assigned to the admin role.
2. Issue the sysShutdown command.
3. At the prompt, enter y.
switch:admin> sysshutdown
This command will shutdown the operating systems on your switch.
You are required to power-cycle the switch in order to restore operation.
Are you sure you want to shutdown the switch [y/n]? y
4. Wait until the following message displays:
Broadcast message from root (ttyS0) Wed Jan 25 16:12:09 2006...
The system is going down for system halt NOW !!
INIT: Switching to runlevel: 0
INIT: Sending processes the TERM signal
Unmounting all filesystems.
The system is halted
flushing ide devices: hda
Power down.
5. Power off the switch.
To power off a Director:
1. From the active CP in a dual CP platform, issue the sysShutdown command.
When the sysShutdown command is issued on the active CP, the active CP, the standby CP, and any
AP blades are all shut down.
2. At the prompt, enter y.
3. Wait until you see the following message:
2006/01/25-17:01:40, [FSSM-1003], 194,, WARNING, NANDU, HA State out of sync
HA is disabled
Broadcast message from root (ttyS0) Wed Jan 25 17:01:41 2006...
The system is going down for system halt NOW !!
INIT: Switching to runlevel: 0
INIT: Sending processes the TERM signal
Unmounting all filesystems.
The system is halted
flushing ide devices: hda
Power down.
4. Power off the switch.
54 Standard features