Downloading Firmware To A Director - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

Hp storageworks fabric os 6.1.1 administrator guide (5697-0235, december 2009)
Hide thumbs Also See for A7533A - Brocade 4Gb SAN Switch Base:
Table of Contents

Advertisement

The firmware is in the form of RPM packages with names defined in a .plist file. The .plist file contains
specific firmware information and the names of packages of the firmware to be downloaded.
4.
Connect to the switch and log in as admin.
5.
Issue the firmwareShow command to check the current firmware version on connected switches.
Upgrade their firmware, if necessary, before you upgrade this switch.
See
"Checking connected
6.
Issue the firmwareDownload command.
7.
Respond to the prompts as follows:
Server Name
or IP Address
User name
File name
Network
protocol
Password
8.
At the Do you want to continue [y/n] prompt, enter y.
9.
After the HA reboot, connect to the switch and log in again as admin.
10.
If you want snapshots of the upgrade progress, use a separate session and issue the
firmwareDownloaStatus command to monitor the firmware download.
1 1.
After the firmware commit is completed, which takes several minutes, issue the firmwareShow
command to display the firmware level of both partitions.
Stealth200E:admin> firmwareDownload
Server Name or IP Address: 192.168.126.115
User Name: userfoo
File Name: /userfoo/firmware/v6.1.0
Network Protocol(1-auto-select, 2-FTP, 3-SCP) [1]: 2
Password:
Checking system settings for firmwareDownload...
Trying address-->AF_INET IP: 192.168.126.115, flags : 2
System settings check passed.
You can run firmwaredownloadstatus to get the status
of this command.
This command will cause a warm/non-disruptive boot on the switch,
but will require that existing telnet or SSH sessions
be restarted.
Do you want to continue [Y]: y
Firmware is being downloaded to the switch. This step may take up to 30 minutes.

Downloading firmware to a Director

You can download firmware to the HP StorageWorks 4/256 SAN Director and DC Director without
disrupting the overall fabric if the two CP blades are installed and fully synchronized. Use the haShow
command to verify that the CPs are synchronized prior to beginning the firmware download process. If only
one CP blade is inserted or powered on, you can run firmwareDownload –s to upgrade the CP. If the
switches" on page 178 for details.
Enter the name or IP address of the FTP server, or SSH server for SCP, where
the firmware file is stored; for example, 192.1.2.3. IP6 and DNS are
supported by firmwareDownload in 5.3.0 and later. If DNS is enabled
and a server name instead of a server IP address is specified in the
command line, firmwareDownload determines whether IP4 or IP6 should
be used.
Enter the user name of your account on the server; for example, JaneDoe.
v6.0.0 or later: Specify the fully-qualified path name of the firmware
directory, for example, /pub/v6.0.0. Absolute path names may be
specified using forward slashes (/).
Specify the file transfer protocol used to download the firmware from the file
server. Valid values are FTP and SCP. The Values are not case-sensitive. If --p
is not specified, firmwareDownload determines the protocol automatically
by checking the config.security parameter on the switch.
Enter the password for the server. This operand can be omitted if firmware
is accessible through a local directory, or if no password is required by the
FTP or SCP server. This operand is required when accessing an SSH server.
Fabric OS 6.1.1 administrator guide 181

Advertisement

Table of Contents
loading

Table of Contents