Fcs Policy Restrictions; Switch Operations - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

Table 25 FCS policy states (continued)
Policy state
Active policy with one entry
Active policy with multiple
entries
The FCS policy is designed to accommodate mixed fabric environments that contain switches with
pre-5.3.0 and later versions of Fabric OS. By setting the configuration parameters to accept fabric
distribution, Fabric OS 6.0.0 and later switches may enforce FCS policy and perform database distribution
among 5.3.0 and 6.0.0 and later switches while still allowing pre-5.3.0 switches to join the fabric. The
following items describe distribution behavior for pre-Fabric OS 5.3.0:
• Distribution to pre-5.3.0 switches with specific Domain IDs
When specific Domain IDs are given for the distribution, all domains must be on a switch with Fabric
OS 5.3.0 or later. If one of the domains is pre-5.3.0 the distribution operation will fail.
• Distribution to pre-5.3.0 switches using the wild card (*) character
When the wild card character is specified, distribution succeeds even if the fabric contains pre-5.3.0
switches. However, the FCS database will be sent only to switches with a Fabric OS of 5.2.0 or later in
the fabric and not to pre-5.2.0 switches. Fabric OS 5.2.0 switches receive the distribution and will
ignore the FCS database.

FCS policy restrictions

The backup FCS switches normally cannot modify the policy. However, if the primary FCS switch in the
policy list is not reachable, a back-up FCS switch will be allowed to modify the policy.
Once an FCS policy is configured and distributed across the fabric, only the primary FCS switch can
perform certain operations. Operations which affect fabric-widefabric-wide configuration are allowed only
from the primary FCS switch. Backup and non-FCS switches cannot perform security, zoning and AD
operations that affect the fabric configuration. The following error message is returned if a backup or
non-FCS switch tries to perform these operations:
Can only execute this command on the primary FCS switch.
Operations that do not affect the fabric configuration, such as show or local switch commands, would be
allowed on back-up and non-FCS switches.
FCS enforcement applies only for user-initiated fabric-widefabric-wide operations. Internal fabric data
propagation because of a fabric merge is not blocked. Consequently, a new switch which joins the FCS
enabled fabric could still propagate the AD and zone database.
Table 26 shows the commands for switch operations for a Primary FCS enforcement.
Table 26

Switch operations

Allowed on FCS switches
secPolicyAdd (Allowed on all switches for
SCC/DCC policies as long as it is not fabric-wide)
secPolicyCreate (Allowed on all switches for
SCC/DCC policies as long as it is not fabric-wide)
secPolicyDelete (Allowed on all switches for
SCC/DCC policies as long as its not fabric-wide)
secPolicyRemove (Allowed on all switches for
SCC/DCC policies as long as its not fabric-wide)
fddcfg –-fabwideset
110 Configuring advanced security features
Characteristics
A primary FCS switch is designated (local switch), but there are no
backup FCS switches. If the primary FCS switch becomes unavailable
for any reason, the fabric is left without an FCS switch.
A primary FCS switch and one or more backup FCS switches are
designated. If the primary FCS switch becomes unavailable, the next
switch in the list becomes the primary FCS switch.
Allowed on all switches
secPolicyShow
fddcfg –localaccept/localreject
userconfig, Passwd, Passwdcfg (Fabric-wide
distribution is not allowed from a backup or
non-FCS switch.)
secPolicyActivate
secPolicySave