Ti Within An Edge Fabric; Traffic Isolation Over Fcr; Ti Zone In An Edge Fabric - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

Edge fabric 1
Figure 30

Traffic isolation over FCR

In addition to setting up TI zones, you must also ensure that the devices are in an LSAN zone, so that they
may communicate with each other.
If failover is enabled and the TI path is not available, an alternate plan is used. If failover is disabled and
the TI path is not available, devices are not imported.
NOTE: For TI over FCR, all switches in the backbone fabric and the edge fabrics must be running Fabric
OS 6.1.0 or later.

TI within an edge fabric

A TI zone within an edge fabric is used to route traffic between a real device and a proxy device through
a particular EX_Port. For example, in
1 and the proxy target is routed through EX_Port 9.
Host 1
Host 2
Figure 31

TI zone in an edge fabric

In the TI zone, when you designate E_Ports between the front and xlate phantom switches, you must use - 1
in place of the I in the D,I notation. Both the front and xlate domains must be included in the TI zone.
Backbone
= Dedicated path set up by TI zone in edge fabric 1
= Dedicated path set up by TI zone in edge fabric 2
= Dedicated path set up by TI zone in backbone fabric
Figure 31, you can set up a TI zone to ensure that traffic between Host
Domain 1
8
1
9
2
E_Ports
= Dedicated Path
= Ports in the TI zone
fabric
Front Domain 3
9
10
-1
EX_Ports
-1
Xlate Domain 4
Fabric OS 6.1.x administrator guide 295
Edge fabric 2
Proxy Target