Command Checklist For Configuring Fcip Links - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

Table 91

Command checklist for configuring FCIP links

Step
1. Configure IPSec policies (optional).
2. Persistently disable ports.
3. If a VEX port is to be implemented,
configure the appropriate virtual port as
a VEX_Port.
4. Configure the IP interface for both
ports of a tunnel.
5. Verify the IP interface for both ports
of a tunnel.
6.Create one or more IP routes
connecting the IP interfaces across the IP
network.
7. Create ARP entry for the IP interface if
VLAN tagging is to be implemented.
(For IPv4 only, not required for IPv6).
8.Test IP connectivity between the local
Ethernet interface (ge0 or ge1) and a
destination IP address.
9. Configure FCIP tunnels.
10. If you are implementing FICON
emulation, configure FICON emulation.
1 1. If you are implementing FTRACE,
configure FTRACE.
12. Verify FCIP tunnels.
13. Enable the ports.
556200 Bps 30s avg, 491394 Bps lifetime avg
Command
policy - -create
portcfgpersistentdisable
portcfgvexport
portcfg ipif
portshow ipif
portcfg iproute
portcfg arp add
portcmd - -ping
portcfg fciptunnel
portcfg ficon
portcfg ftrace
portshow fciptunnel
portpersistentenable
Fabric OS 6.1.x administrator guide 421