Iscsi Virtual Target Configuration - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

4. (Optional) Issue the portCfg command to define static routes to reach the destination IP through a
preferred gateway:
switch:admin> portcfg iproute 3/ge0 create 0.0.0.0 0.0.0.0 30.0.0.1 1
Operation Succeeded
The gateway must be on the same subnet as the GbE port. You can specify a maximum of 32 routes
per GbE port.
5. (Optional) Verify the route as follows:
switch:admin> portshow iproute 3/ge0
Slot: 3 Port: ge0
IP AddressMaskGatewayMetricFlags
------------------------------------------------------------------
0.0.0.0
30.0.0.0
6. Issue the portCmd --ping command to verify the network connection:
switch:admin> portcmd --ping 3/ge0 -s 30.0.127.30 -d 30.0.0.1
Pinging 30.0.0.1 from ip interface 30.0.127.30 on 3/ge0 with 64 bytes of data
Reply from 30.0.0.1: bytes=64 rtt=0ms ttl=255
Reply from 30.0.0.1: bytes=64 rtt=0ms ttl=255
Reply from 30.0.0.1: bytes=64 rtt=0ms ttl=255
Reply from 30.0.0.1: bytes=64 rtt=0ms ttl=255
Ping Statistics for 30.0.0.1:
Packets: Sent = 4, Received = 4, Loss = 0 ( 0 percent loss)
Min RTT = 0ms, Max RTT = 0ms Average = 0ms
7. (Optional) Issue the portCfg arp command to configure additional ARP entries:
switch:admin> portcfg arp 3/ge0 add 30.0.30.11 00:0F:1F:69:99:88
Operation Succeeded
8. (Optional) Verify the entry by issuing the portShow command.
switch:admin> portshow arp 3/ge0
Slot: 3 Port: ge0
IP AddressMac AddressFlags
-----------------------------------------------------------
30.0.30.214
30.0.0.1
30.0.30.11

iSCSI Virtual Target Configuration

Configuring an iSCSI environment involves creating iSCSI virtual targets (VTs), discovery domains (DDs),
discovery domain sets (DDSets), and defining iSCSI VT-iSCSI initiator authentication.
NOTE: You can also configure iSCSI virtual targets through the Web Tools Graphical User Interface as an
alternative to the command line interface. See the Web Tools Administrator's Guide for descriptions of
GUI-based configuration procedures.
Create iSCSI VTs using the LUN values of FC targets. The FC target must be accessible from the iSCSI
gateway. iSCSI VTs can be automatically generated or manually created.
After mapping iSCSI targets do not move the targets out of Administrative Domain 0 (AD0), unless you
then explicitly add them back to AD0.
264 iSCSI Gateway services
0.0.0.0 30.0.0.1
255.255.0.0 30.0.127.30
00:c0:dd:07:81:13 Resolved
00:11:93:58:fd:7f Resolved
00:0f:1f:69:99:88 Permanent Resolved
1
0 Interface