Displaying An Ip Filter Policy; Saving An Ip Filter Policy; Activating An Ip Filter Policy; Deleting An Ip Filter Policy - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

Displaying an IP Filter policy

You can Display the IP Filter policy content for the specified policy name, or all IP Filter policies if policy
name is not specified.
For each IP Filter policy, the policy name, type, persistent state and policy rules are displayed. The policy
rules are listed by the rule number in ascending order. There is no pagination stop for multiple screens of
information. Pipe the output to the more command to achieve this.
If a temporary buffer exists for an IP Filter policy, the
temporary buffer, with the persistent state set to no.
To display an IP Filter policy:
1. Log in to the switch using an account assigned to the admin role.
2. Issue the following command:
ipfilter –-show <policyname>
where
policyname
<

Saving an IP Filter policy

This will save one or all IP Filter policies persistently in the defined configuration. The policy name is
optional for this sub-command. If the policy name is given, the IP Filter policy in the temporary buffer will
be saved; if the policy name is not given, all IP Filter policies in the temporary buffer will be saved. Only
the CLI session that owns the updated temporary buffer may run this command. Modification to an active
policy cannot be saved without being applied. Hence, the
policies. Use
--
To save an IP Filter policy:
1. Log in to the switch using an account assigned to the admin role.
2. Issue the following command:
ipfilter –-save [policyname]
where
[policyname]

Activating an IP Filter policy

IP Filter policies are not enforced until they are activated. Only one IP Filter policy per IPv4 and IPv6 type
can be active. If there is a temporary buffer for the policy, the policy is saved to the defined configuration
and activated at the same time. If there is no temporary buffer for the policy, the policy existing in the
defined configuration will become active. The activated policy continues to remain in the defined
configuration. The policy to be activated will replace the existing active policy of the same type. Activating
the default IP Filter policies will return the IP management interface to its default state. An IP Filter policy
without any rule cannot be activated. This sub-command will prompt for a user confirmation before
proceeding.
To activate an IP Filter policy:
1. Log in to the switch using an account assigned to the admin role.
2. Issue the following command:
ipfilter –-activate <policyname>
where
<policyname>

Deleting an IP Filter policy

You can delete a specified IP Filter policy. Deleting an IP Filter policy will remove it from the temporary
buffer. To permanently delete the policy from persistent database, run ipfilter
Filter policy cannot be deleted.
To delete an IP Filter policy:
is the name of the policy.
>
activate instead.
is the name of the policy and is optional.
is the name of the policy.
show sub-command displays the content in the
--
save sub-command is blocked for the active
--
Fabric OS 6.1.1 administrator guide 125
save. An active IP
--