Switch In Access Gateway Mode Without F_Port Trunking; Switch In Access Gateway Mode With F_Port Masterless Trunking - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual
Hp storageworks fabric os 6.1.1 administrator guide (5697-0235, december 2009)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Administrator's manual (576 pages) ,
- Hardware reference manual (256 pages) ,
- User manual (248 pages)
Table of Contents
Advertisement
work on M-EOS or third party switches.
Figure 47
shows a switch in AG mode without F_Port masterless
trunking.
Figure 48
shows a switch in AG mode with F_Port masterless trunking.
Figure 47
Switch in Access Gateway mode without F_Port trunking
Figure 48
Switch in Access Gateway mode with F_Port masterless trunking
NOTE:
You do not need to map the host to the master port manually because Access Gateway performs
a cold failover to the master port.
To implement F_Port masterless trunking, you must first configure an F_Port trunk group and statically assign
an Area_ID within the trunk group. Assigning a Trunk Area (TA) to a port or trunk group enables F_Port
masterless trunking on that port or trunk group. When a TA is assigned to a port or trunk group, the ports
immediately acquire the TA as the area of its PID. When a TA is removed from a port or trunk group, the
ports will revert to the default area as its PID.
376 Administering ISL trunking
Advertisement
Table of Contents
