HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual page 139

To set up LDAP for FIPS mode:
Set the switch authentication mode and add your LDAP server by using the commands in the example
1.
below. Provide the Fully Qualified Domain Name (FQDN) of the Active Directory server for the
hostname parameter while configuring LDAP.
Example of setting up LDAP for FIPS mode:
switch:admin> aaaconfig --add GEOFF5.ADLDAP.LOCAL -conf ldap -d
389 -t 3
switch:admin> aaaconfig --authspec "ldap;local"
switch:admin> aaaconfig –show
RADIUS CONFIGURATIONS
=====================
RADIUS configuration does not exist.
LDAP CONFIGURATIONS
===================
Position
Server
Port
Domain
Timeout(s)
Primary AAA Service: LDAP
Secondary AAA Service: Switch database
2. Issue the dnsConfig command to configure the DNS on the switch.
Example of setting the DNS:
switch:admin> dnsconfig
Enter option
1 Display Domain Name Service (DNS) configuration
2 Set DNS configuration
3 Remove DNS configuration
4 Quit
Select an item: (1..4) [4] 2
Enter Domain Name: [] domain.com
Enter Name Server IP address in dot notation: [] 123.123.123.123
Enter Name Server IP address in dot notation: [] 123.123.123.124
DNS parameters saved successfully
Enter option
1 Display Domain Name Service (DNS) configuration
2 Set DNS configuration
3 Remove DNS configuration
4 Quit
Select an item: (1..4) [4] 4
Specify the DNS IP address using either IPv4 or IPv6. This is needed for the switch to resolve the
domain name to the IP address as LDAP initiates a TCP session to connect to your Microsoft Active
Directory server. A Fully Qualified Domain Name (FQDN) is needed to validate the server identity as
mentioned in the common name of the server certificate.
3. Set up LDAP according to the instructions in
page 71.
: 1
: GEOFF5.ADLDAP.LOCAL
: 389
: adldap.local
: 3
"LDAP configuration and Microsoft's Active
adldap.local -p
Directory" on
Fabric OS 6.1.1 administrator guide 139