HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual page 217
Hp storageworks fabric os 6.1.1 administrator guide (5697-0235, december 2009)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Administrator's manual (576 pages) ,
- Hardware reference manual (256 pages) ,
- User manual (248 pages)
Table of Contents
Advertisement
where:
cfgname
The name of the zone configuration.
member
The zone name or list of zone names to be added to the configuration.
3.
Issue the cfgSave command to save the change to the defined configuration.
switch:admin> cfgadd "newcfg", "bluezone"
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined zoning configuration only? (yes, y, no, n): [no] y
To remove zones (members) from a zone configuration:
1.
Connect to the switch and log in as admin.
2.
Issue the cfgRemove command with the following syntax:
cfgremove "cfgname", "member[; member...]"
where:
cfgname
The name of the zone configuration.
member
The zone name or list of zone names to be removed from the
configuration.
3.
Issue the cfgSave command to save the change to the defined configuration.
switch:admin> cfgremove "NEW_cfg", "redzone"
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined zoning configuration only? (yes, y, no, n): [no] y
To delete a zone configuration:
1.
Connect to the switch and log in as admin.
2.
Issue the cfgDelete command with the following syntax:
cfgdelete "cfgname"
where cfgname is the name of the defined zone configuration to be deleted.
3.
Issue the cfgSave command to save the change to the defined configuration.
switch:admin> cfgdelete "testcfg"
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined zoning configuration only? (yes, y, no, n): [no] y
To clear changes to a configuration:
1.
Issue the cfgTransAbort command.
When this command is executed, all changes since the last save operation (performed with the
cfgSave command) are cleared.
In the following example, assume that the removal of a member from zone1 was done in error:
Fabric OS 6.1.1 administrator guide 217
Advertisement
Table of Contents
