Backing Up System Configuration Settings - HP A7340A - Surestore FC 1Gb/2Gb Switch 16B Installation Manual

Backing Up the Configuration and Upgrading Firmware

Backing Up System Configuration Settings

HP strongly recommends saving the configuration after the initial configuration
changes and periodically thereafter.
FTP must be used on Windows workstations to back up the system configuration.
The FTP server must be running before an upload can occur. Use the RSHD
service or FTP on a UNIX machine.
Note:
uploads for Windows, only downloads. These utilities are available from the support
website:
http://www.hp.com/support/
Use these steps to upload a backup copy of the configuration settings to a host
computer.
1. Verify that the RSHD service (on a UNIX machine) or the FTP service (on a
2. Log into the switch as the admin user.
3. At the command line enter the following command:
For example, hostIPaddr is the IP address of the host computer, user is the
User ID used to log into this computer, path_filename is the path location
and filename of the configuration file, and password is the password for the
user ID specified.
If only configupload is entered, the system will prompt you for each
parameter, as follows:
86
The two supplied utilities, RSHD.EXE and CAT.EXE, currently do not support
Windows or UNIX machine) is running on the host workstation.
configUpload hostIPaddr user path_filename password
Example:
switch:admin> configupload
Server Name or IP Address [host]: 123.45.678.901
User Name [user]: kelev
File Name [config.txt]: switch1
Protocol (RSHD or FTP) [rshd]: ftp
Password:
upload complete
SAN Switch 2/16 Version 3.1.x Installation Guide