Backing Up the Configuration and Upgrading Firmware
Upgrading or Restoring the Switch Firmware
The SAN Switch 2/16 ships with preloaded firmware. In most cases, there is no
need to update the firmware on the new switch. The firmware version can be
determined by using:
Use these steps to upgrade or restore the switch firmware.
1. Verify that the RSHD service (on a UNIX machine) or the FTP service (on a
2. Log into the switch as the admin user.
3. At the command line, enter the following command:
For example, where hostIPaddr is the IP address of the host computer, user
is the User ID used to log into this computer, path_filename is the path
location and filename of the new firmware file, and password is the
password for the user ID specified.
Note:
4. Reboot the switch by entering the following command:
88
The version command via Telnet
The Switch Management Application page in Web Tools
Windows or UNIX machine) is running on the host workstation.
firmwareDownload hostIPaddr, user, path_filename,
password
The password operand is only required if you are using FTP.
fastBoot
SAN Switch 2/16 Version 3.1.x Installation Guide