Attaching The Rear Or Front Rack Mount Brackets; Securing The Inner Slide Rails To The Switch - HP A7340A - Surestore FC 1Gb/2Gb Switch 16B Installation Manual

3. Tighten the screws and torque to 15-inch pounds.
Figure 4: Securing the inner slide rails to the switch
4. Repeat steps 1 and 2 to attach the second inner slide rail to the switch. Make

Attaching the Rear or Front Rack Mount Brackets

The Rack Mount Kit supplied with the switch contains two rear rack mount
brackets and two front rack mount brackets. To prevent the switch from
accidentally sliding out of the rack, install these rack mount brackets as described
in the following section.
Note:
the back of the HP 9000 Series rack. (For example, the switch should face the aisle
where exhaust air is released. Air intake and exhaust for all components in the rack
should flow in the same direction.)
SAN Switch 2/16 Version 3.1.x Installation Guide
sure to orient the second inner slide rail in the same way you positioned the
first (based on 1a or 1b above).
HP recommends installing the switch so that the port side of the switch slides out
Installing the SAN Switch 2/16
SHR-2477A
33