Modifying Domain Ids - HP A7340A - Surestore FC 1Gb/2Gb Switch 16B Installation Manual

Modifying Domain IDs

Optional. Modify the domain IDs, if desired, as follows.
Note:
switch is connected to the fabric, the domain ID for the new switch is automatically
reset to a unique value. The domain IDs that are currently in use can be determined
using the telnet command fabricShow.
1. Disable the switch by entering the following:
2. Enter the following:
3. Enter y after the Fabric parameters prompt.
4. Enter a unique domain ID (such as the domain ID used by the previous
5. Complete the remaining prompts (or press CTRL+D to accept the remaining
6. Re-enable the switch by entering the following:
SAN Switch 2/16 Version 3.1.x Installation Guide
The default domain ID is 1. If the default domain ID is already in use when the
switchDisable
configure
Fabric parameters (y, n)
switch, if still available).
Domain: (1..239) [1] 3
settings without completing all the prompts).
switchEnable
Installing the SAN Switch 2/16
65