For Front Rack Access; Attaching The Outer Slide Rails - HP A7340A - Surestore FC 1Gb/2Gb Switch 16B Installation Manual

For Front Rack Access

Use these steps to attach the front rack mount brackets to the switch. The front
rack mount brackets act as stops to prevent the switch from sliding out the front of
the rack. Use these steps if you installed the inner slide rails to the switch using
the procedure outlined in
on page 32.
1. Align the right rack mount bracket with the two screw holes at the end of the
2. Locate two slotted-head Phillips head 8-32 x 3/8-inch screws and two lock
3. Secure the right mount bracket to the end of the inner slide rail using the
4. Tighten the screws and torque to 15-inch pounds.
5. Repeat steps 1 through 4 to install the left mount bracket onto the second

Attaching the Outer Slide Rails

Use the following steps to install the outer slide rails in the HP 9000 Series Rack.
Note:
the HP 9000 Series Rack.
Obtain the following items, located in the Rack Mount Kit:
SAN Switch 2/16 Version 3.1.x Installation Guide
inner rails on the right, power supply end of the switch.
nuts contained in the Rack Mount Kit accessory pouch.
screws and lock nuts.
inner slide rail.
This procedure requires two technicians to properly align the outer slide rails in
Four 3-hole bar nuts
Eight Phillips head 8-32 x 3/8-inch screws
Eight square alignment washers
# 2 Phillips screwdriver with torque capability
"Attaching the Inner Slide Rails to the
Installing the SAN Switch 2/16
Switch," step 1b
35