Installing The San Switch 2/16 In An Hp 9000 Series Or Comparable Eia Rack; Installing The Slide Rail Assemblies To The Switch; Separating The Inner Slide Rail Assembly From The Outer Slide Rail Assembly - HP A7340A - Surestore FC 1Gb/2Gb Switch 16B Installation Manual

Installing the SAN Switch 2/16 in an HP 9000 Series or
Comparable EIA Rack
Read the following sections to install the switch in a rack using the Rack Mount
Kit supplied with the switch. Obtain the following tools:

Installing the Slide Rail Assemblies to the Switch

The Rack Mount Kit supplied with the switch consists of two slide rail assemblies
consisting of an inner slide rail attached to an outer slide rail. Read the following
sections for complete instructions on first separating, then installing the slide rail
assemblies.
Separating the Inner Slide Rail Assembly from the
Outer Slide Rail Assembly
First, separate the two inner (smaller) slide rails from the two outer (larger) slide
rails as follows.
1. Holding one slide rail assembly horizontally, pull the inner slide rails out of
2. Press the lock release lever located on the inner slide rails. The inner slide rail
3. Repeat steps 1 and 2 to separate the second slide rail assembly.
4. Put the outer slide rails aside. Follow the steps in the next section,
SAN Switch 2/16 Version 3.1.x Installation Guide
A #2 Phillips screwdriver
Torque screwdriver
the outer slide rail until the lock release lever engages.
separates from the outer slide rail.
the Inner Slide Rails to the Switch."
Installing the SAN Switch 2/16
"Attaching
31