Installing the SAN Switch 2/16
4. Install two M5 U-type Tinnerman clips for each of the front columns of the
Figure 9: Installing the tinnerman clips
5. Assemble the outer rails by completing the following steps:
42
rack in the top and bottom positions of the three-hole pattern as shown in
Figure
9.
a. As an aid in assembly, two rubber washers have been included to help
keep the rear slotted portion of the outer rail flush against the rear rail-tray
brackets. Install them as shown in
Figure
10.
SAN Switch 2/16 Version 3.1.x Installation Guide