Installing The San Switch 2/8 In An Hp 9000 Series Or Comparable Eia Rack; Installing The Fixed Rail Kit - HP StorageWorks 2/8-EL - SAN Switch Installation Manual

Installing the SAN Switch 2/8 in an HP 9000 Series or
Comparable EIA Rack
Read the following sections for complete installation instructions.
Obtain the following tools:

Installing the Fixed Rail Kit

The SAN Switch 2/8 Fixed Rack Mount Kit consists of two rail assemblies. Read
the following sections for complete instructions on attaching the rails to the
switch, then installing the switch in the rack.
1. Attach the left and right front brackets to the switch chassis as follows:
Note:
of the rack, if desired. This allows a more gradual bend in any fiber optic cables
connected to the switch.
SAN Switch 2/8 Version 3.1.x Installation Guide
Fixed Rack Mount Kit (supplied with the switch)
A #2 Phillips screwdriver with torque capability
Clamps or other means to temporarily support the switch
Torque screwdriver
Caution: The SAN Switch 2/8 ships with the complete set of rack mount
hardware required for installation in an EIA rack. HP recommends using the
exact screws specified for use with the switch chassis. Using screws longer
than the specified length may damage the switch.
a. Position one left front bracket (Item 1) with the flat side against right side
of switch, oriented as shown in
Four sets of holes are provided to allow the switch to be set back from the front
b. Insert two 8-32 x 5/16 inch screws (Item 7) into one of the pairs of
vertically aligned holes in both the bracket and in the switch.
c. Insert one 8-32 x 5/16 inch screw (Item 7) into one of the single holes in
both the bracket and in the switch.
d. Tighten screws to a torque of 15-inch pounds.
Installing the SAN Switch 2/8
Figure 6.
33