802.1X Port Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

802.1x Global Configuration commands
Table 102
Command
show dot1x

802.1x Port configuration

The 802.1x port commands allow you to configure parameters that affect the selected port in the switch.
These settings override the global 802.1x parameters.
The following table describes the 802.1x Port Configuration commands.
802.1x Port Configuration commands
Table 103
Command
dot1x mode {[force-unauthorized|
auto|force-authorized]}
dot1x quiet-time {<0-65535>}
dot1x transmit-interval
{<1-65535>}
dot1x supplicant-timeout
{<1-65535>}
dot1x server-timeout {<1-65535>}
dot1x max-request {<1-10>}
Description
Displays current global 802.1x parameters.
Command mode: All
Description
Sets the type of access control for the port:
force-unauth—the port is unauthorized unconditionally.
auto—the port is unauthorized until it is successfully authorized
by the RADIUS server.
force-auth—the port is authorized unconditionally, allowing
all traffic.
The default value is force-auth.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits before transmitting
an EAP-Request/Identity frame to the supplicant (client) after an
authentication failure in the previous round of authentication. The
default value is 60 seconds.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits for an EAP-
Response/Identity frame from the supplicant (client) before
retransmitting an EAP-Request/Identity frame. The default value is
30 seconds.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits for an EAP-
Response packet from the supplicant (client) before retransmitting
the EAP-Request packet from the authentication server. The default
value is 30 seconds.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits for a response
from the RADIUS server before declaring an authentication timeout.
The default value is 30 seconds.
Command mode: Interface port
Sets the maximum number of times the authenticator retransmits an
EAP-Request packet to the supplicant (client). The default value is 2.
Command mode: Interface port
Configuration Commands
128