HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual page 133

CIST Port Configuration commands
Table 107
Command
spanning-tree mstp cist hello
{<1-10>}
spanning-tree mstp cist link-
type {auto|p2p|shared}
[no] spanning-tree mst cist
edge
spanning-tree mst cist enable
no spanning-tree mst cist
enable
show interface port {<port
number>} spanning-tree mstp
cist
Description
Configures the CIST port Hello time. The Hello time specifies how
often the root bridge transmits a configuration bridge protocol data
unit (BPDU). Any bridge that is not the root bridge uses the root bridge
Hello value. The range is 1 to 10 seconds, and the default is
2 seconds.
Command mode: Interface port
Defines the type of link connected to the port, as follows:
auto—Configures the port to detect the link type, and
automatically match its settings.
p2p—Configures the port for Point-To-Point protocol.
shared—Configures the port to connect to a shared medium
(usually a hub).
The default link type is auto.
Command mode: Interface port
Enables or disables this port as an edge port. An edge port is not
connected to a bridge, and can begin forwarding traffic as soon as
the link is up. Configure server ports as edge ports (enabled). This
command is disabled by default.
Command mode: Interface port
Enables CIST on the port.
Command mode: Interface port
Disables CIST on the port.
Command mode: Interface port
Displays the current CIST port configuration.
Command mode: All
Configuration Commands
133