Radius Server Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

SSHD Configuration commands
Table 78
Command
no ssh enable
show ssh

RADIUS server configuration

NOTE: See the HP 10Gb Ethernet BL-c Switch Application Guide for information on RADIUS.
The following table describes the RADIUS Server Configuration commands.
RADIUS Server Configuration commands
Table 79
Command
[no] radius-server primary-host
<IP address> key <1-32 characters>
[no] radius-server secondary-host
<IP address> key <1-32 characters>
radius-server port <UDP port
number>
radius-server retransmit <1-3>
radius-server timeout <1-10>
[no] radius-server telnet-backdoor
[no] radius-server secure-backdoor
radius-server enable
Description
Disables the SSH server. This is the default for the SSH server.
Command mode: Global configuration
Displays the current SSH server configuration.
Command mode: All
Description
Sets the primary RADIUS server address and shared secret
between the switch and the RADIUS server(s).
Command mode: Global configuration
Sets the secondary RADIUS server address and shared secret
between the switch and the RADIUS server(s).
Command mode: Global configuration
Enter the number of the User Datagram Protocol (UDP) port to be
configured, between 1500-3000. The default is 1645.
Command mode: Global configuration
Sets the number of failed authentication requests before switching
to a different RADIUS server. The range is 1-3 requests. The
default is 3 requests.
Command mode: Global configuration
Sets the amount of time, in seconds, before a RADIUS server
authentication attempt is considered to have failed. The range is
1-10 seconds. The default is 3 seconds.
Command mode: Global configuration
Enables or disables the RADIUS back door for
telnet/SSH/HTTP/HTTPS. This command does not apply when
secure backdoor is enabled.
Command mode: Global configuration
Enables or disables the RADIUS back door using secure password
for telnet/SSH/HTTP/HTTPS. This command does not apply when
backdoor (telnet) is enabled.
Command mode: Global configuration
Enables the RADIUS server.
Command mode: Global configuration
Configuration Commands
106