Ospf Interface Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Reference Manual

OSPF Interface Configuration

To display the following form, go to the OSPF Interfaces Configuration form. Select an interface number,
or open the OSPF Interfaces folder and click Add OSPF Interface.
The following table describes the OSPF Interface Configuration controls:
OSPF Interface Configuration controls
Table 154
Control
IP Interface Identifier (1-256)
Area Number (0-2)
Enabled?
Router Priority (0-255)
Output Cost (1-65535)
Hello Interval (1-65535 sec)
Dead Interval (1-65535 sec)
Transit Delay (1-3600 sec)
Descriptions
Assigns a numeric identifier to the OSPF IP interface.
Defines the area index used by the interface.
Enables or disables the OSPF interface.
Displays the assigned priority value to the OSPF interfaces.
(A priority value of 255 is the highest and 1 is the lowest. A priority value of 0
specifies that the interface cannot be used as Designated Router (DR) or Backup
Designated Router (BDR).)
Displays cost set for the selected path—preferred or backup. Usually the cost is
inversely proportional to the bandwidth of the interface. Low cost indicates high
bandwidth.
Displays the interval in seconds between the hello packets for the interfaces.
Displays the health parameters of a hello packet, which is set for an interval of
seconds before declaring a silent router to be down.
Displays the transit delay in seconds.
Configuring the switch
218