Fdb Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Reference Manual

Table 111 Port 802.1x Configuration controls
Control
Server Timeout (0-65535 sec)
ReAuth Status
ReAuth Period (1-604800 sec)
Overwrite Configuration with

FDB Configuration

To display the following form, select Layer 2 > FDB (click the underlined text, not the folder).
The following table describes the FDB Configuration controls:
FDB Configuration controls
Table 112
Control
Bridge Aging Time
(0-65535 secs)
Description
Sets the time, in seconds, the authenticator waits for a response from the
Radius server before declaring an authentication timeout. The default value is
30 seconds.
The time interval between transmissions of the RADIUS Access-Request packet
containing the supplicant's (client's) EAP-Response packet is determined by the
current setting of /cfg/sys/radius/timeout (default is 3 seconds).
Sets the re-authentication status to on or off. The default value is off.
Sets the time, in seconds, the authenticator waits before re-authenticating a
supplicant (client) when periodic re-authentication is enabled. The default
value is 3600 seconds.
Overwrites the port configuration settings with the global or default 802.1x
settings.
Description
Configures the forwarding database aging time. The aging time specifies the amount of time
the STP bridge waits without receiving a packet from a station before removing the station
from the forwarding database. The default value is 300 seconds.
To disable FDB aging, set the value to 0.
Configuring the switch
166