New Connection Dialog Box - HP StorageWorks Edge Switch 2/12 Installation Manual

Perform the following steps to change a switch's IP address, subnet mask, or
gateway address:
1. Remove the protective cover from the 9-pin maintenance port at the rear of
2. Connect the other cable end to a 9-pin communication port (COM1 or
3. Power on the maintenance terminal. After the PC powers on, the Windows
Note:
communication software are described in
4. Choose Start > Programs > Accessories > Communications >
Figure 6: New Connection dialog box
Edge Switch 2/12 Installation Guide
the switch (#2 Phillips screwdriver is required). Connect the 9-pin end of the
RS-232 null modem cable to the port.
COM2) at the rear of the maintenance terminal PC.
desktop displays. Refer to operating instructions shipped with the PC.
Procedures for changing network addresses using the HyperTerminal serial
HyperTerminal. The New Connection dialog box displays
Installing and Configuring the Edge Switch 2/12
step 4 through step 13.
(Figure 6).
41