Editing The Switch Membership List - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Optional Features
4. Click Activate to enable the changes and close the dialog box.
5. Edit the Switch Membership List through the Switch Binding Membership

Editing the Switch Membership List

1. Select the Edit Membership List option from the Configure menu's Switch
Note:
on how the Switch Membership List is populated with WWNs according to options set
in the Switch Binding State Change dialog box.
2. If nicknames are configured for WWNs through the HAFM and you want
3. To prohibit connection to a switch port from a WWN currently in the
172
Restrict All. Select if you want to restrict connections from specific devices
to Edge Switch F_Ports and Edge Switches to Edge Switch E_Ports. Device
and switch WWNs can be added to the Switch Membership List to allow
connection and removed from the Membership List to prohibit connection.
List dialog box to add or remove switches and devices that are allowed to
connect with the switch. Refer to following section for procedures.
Binding submenu in the Product Manager. The Switch Binding
Membership List dialog box displays. The WWNs of devices and/or
switches that can currently connect to switch ports are listed in the Switch
Membership List panel.
Refer to "Configuring Switch Binding -
these to display instead of WWNs in this dialog box, click the Display
Options button at the bottom of the dialog box. When the Display Options
dialog box displays, click Nickname, then OK.
Membership List, click the WWN or nickname in the Membership List, then
click the Remove button. The WWN or nickname will move to the Node List
panel. WWNs can only be removed from the fabric if any of the following is
true:
— The switch is offline.
— Switch Binding is disabled.
— The switch or device with the WWN is not connected to the switch.
— Switch Binding is not enabled for the same port type as enabled for the
Connection Policy in the Switch Binding State Change dialog box. For
example, a WWN for a switch attached to an E_Port can be removed if
the Switch Binding Connection Policy was enabled to Restrict F_Ports.
Overview" on page 170 for information
Edge Switch 2/24 Product Manager User Guide