HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 186

Product Manager Messages
Table 5: StorageWorks Edge Switch 2/24 Product Manager Messages (Continued)
Are you sure you want to
send firmware version?
Cannot disable Switch
Binding while Enterprise
Fabric Mode is active
and the switch is Online.
Cannot disable Insistent
Domain ID while Fabric
Binding is active.
Cannot enable
beaconing on a failed
FRU.
Cannot enable
beaconing while the
system error light is on.
184
Message
Confirmation to send a
firmware version to the
switch.
User attempted to
disable switch binding
through the Switch
Binding Change State
dialog box, but
Enterprise Fabric Mode
is enabled.
User attempted to
disable the Insistent
Domain ID parameter
through the Configure
Switch Parameters
dialog box, but Fabric
Binding is enabled.
Occurs when selecting
Enable Beaconing option
for a failed FRU.
Beaconing cannot be
enabled while the system
error light is on.
Description
Edge Switch 2/24 Product Manager User Guide
Action
Click Yes to confirm
sending the firmware
version to the switch, or no
to cancel the operation.
You must either disable
Enterprise Fabric Mode
using the Enterprise Fabric
Mode dialog box in the
HAFM application or set
the switch offline before you
can disable Switch Binding.
Disable Fabric Binding
through the Fabric Binding
dialog box before disabling
these parameters.
Replace FRU and enable
beaconing again or enable
beaconing on operating
FRU.
Select Clear System Error
Light from Product menu to
clear error light, then
enable beaconing.