HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 190

Product Manager Messages
Table 5: StorageWorks Edge Switch 2/24 Product Manager Messages (Continued)
Cannot start data
collection.
Cannot start firmware
install while CTP
synchronization is in
progress.
Cannot start port
diagnostics.
Cannot swap an
uninstalled port.
Click OK to remove all
contents from log.
Continuing may
overwrite host
programming. Continue?
Could not export log to
file.
Could not find firmware
file.
Could not find firmware
file.
Could not remove dump
files from server.
Could not stop port
diagnostics.
188
Message
Data collection cannot
be started. The link is
down or busy.
CTP synchronization is in
progress while you are
attempting to install
firmware.
Port diagnostics cannot
be started. The link is
down or busy.
A port swap cannot be
performed when the port
is not installed.
Requesting confirmation
that you want all contents
removed from the log.
Configurations sent from
the host may be
overwritten by HAFM.
A file I/O error
occurred. The log file
could not be saved to the
specified destination.
Firmware file selected
was not found in the FTP
directory.
The selected file is not a
firmware file.
Dump files could not be
removed from server.
Link may be down or
switch may be busy.
Port diagnostics could
not be stopped. Link may
be down or switch may
be busy.
Description
Edge Switch 2/24 Product Manager User Guide
Action
Retry the operation later. If
the condition persists,
contact support personnel.
Wait for the CTP
synchronization to complete
before starting the firmware
install.
Retry the operation later. If
the condition persists,
contact support personnel.
Perform a swap only on a
port that is installed.
Click OK to continue or
Cancel to cancel the
operation.
Continuing will activate the
current configuration, which
may have been configured
by a FICON host.
Ensure file name and drive
are correct.
Ensure file name and
directory are correct.
Obtain a valid firmware file
from your service
representative.
Retry the operation later. If
the condition persists,
contact support personnel.
Retry the operation later. If
the condition persists,
contact support personnel.