Configure Switch Binding; Configure Ports - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Fw 05.01.00 and sw 07.01.00 edge switch 2/24 product manager user guide
Hide thumbs Also See for 316095-B21 - StorageWorks Edge Switch 2/24:
Table of Contents

Advertisement

Configure Switch Binding

For complete procedures for configuring this optional feature, refer to
Binding" on page 170.

Configure Ports

Use the procedures in this section to configure ports. Port configuration data is
stored in NV-RAM on the switch.
Port information includes:
Note:
over the ports in the Hardware View. As you move over a port, a message displays that
identifies the slot number where the port is installed.
Edge Switch 2/24 Product Manager User Guide
Port #
You cannot edit this field. This column identifies the port number. The port
numbers range from 0 through 23.
Name
Enter a name for the port. The port names display in the Port Properties
dialog box and elsewhere in the Product Manager to identify the port.
To identify port numbers for which you want to provide names, place the cursor
Blocked
Placing a check mark in the check boxes of this column blocks the operation
of the port.
LIN Alerts
A link incident (LIN) is a problem detected on a fiber optic link, such as the
loss of light or invalid sequences. When a problem occurs, a LIN alert is sent
to the Link Incident Log in the switch Product Manager. LIN alerts warn you
that there is a link incident being detected through a port connection.
Place or remove check marks in the check boxes in this column to enable or
disable link incident alerts. The factory default is to enable LIN alerts.
A link incident causes a yellow attention indicator (triangle) to display for the
port in the Hardware View and in the alert column of the Port List View.
Once a LIN occurs, you must acknowledge it by selecting the Clear Link
Configuring the Switch
"Switch
111

Advertisement

Table of Contents
loading

Table of Contents