Wireless Settings - NETGEAR ProSafe WG102 Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102

Wireless Settings

To configure the wireless settings, click Wireless Settings in the Setup section of the WG102 main
menu. The Wireless Settings menu appears, as shown below.
Figure 3-8
The Wireless Settings menu options are discussed below.
Note: Channel selection and power management are automatically adjusted by the
AutoCell Auto RF Management option. The Auto RF Management option is
enabled by default..
• Country/Region. This is the region where the WG102 can be used. It may not be legal to
operate the wireless features of the wireless access point in a region other than one of those
identified in this field. For products sold in the United States, the default country domain is
preset. Also, the channel is set to 11. For products sold outside the United States, unless a
country domain is selected, the channel cannot be changed.
• Turn Radio On. On by default, you can also turn off the radio to disable access through this
device. This can be helpful for configuration, network tuning, or troubleshooting activities.
• Operating Mode. Select the desired wireless operating mode. The options are:
– Auto (802.11g/802.11b): Both 802.11g and 802.11b wireless stations can be used. This is
the default.
– 802.11g Only: Only 802.11g wireless stations can be used.
3-12
v1.0, November 2005