Front Fan Assembly - HP SignagePlayer mp8000r Maintenance And Service Manual
Maintenance & service guide: hp signageplayer mp8000r and mp8000s
Hide thumbs
Also See for SignagePlayer mp8000r:
- Illustrated parts and service map (4 pages) ,
- Getting started manual (36 pages)
Table of Contents
Advertisement
Front Fan Assembly
The front fan assembly is attached to the front of the chassis.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the baffle
5.
Disconnect the fan cable from the red/brown system board connector labeled CHFAN1.
6.
Press the two tabs (one of left, one on bottom) that secure the fan assembly to the front of the
chassis.
Figure 6-55
7.
Pull the assembly toward the rear of the unit, and then lift it out of the chassis.
To install the front fan, reverse the removal procedure. Be sure to orient the air flow into the unit.
78
Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
(Preparation for Disassembly on page
(Computer Access Panel on page
(Front Bezel on page
(Baffle on page
77).
Removing the front fan
43).
44).
35).
Advertisement
Table of Contents
