Computer Setup-Security - HP SignagePlayer mp8000r Maintenance And Service Manual

Table 3-3 Computer Setup—Storage (continued)
DPS Self-Test
Boot Order
Computer Setup—Security
NOTE:
Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 3-4 Computer Setup—Security
Option
Setup Password
Power-On
Password
Password Options
(This selection appears
only if a power-on
password or setup
password is set.)
Allows you to execute self-tests on ATA hard drives capable of performing the Drive Protection
System (DPS) self-tests.
NOTE: This selection will only appear when at least one drive capable of performing the DPS self-
tests is attached to the system.
Allows you to:
●
Specify the order in which attached devices (such as a USB flash media device, hard drive,
network interface card) are checked for a bootable operating system image. Each device on
the list may be individually excluded from or included for consideration as a bootable
operating system source.
● Specify the order of attached hard drives. The first hard drive in the order will have priority in
the boot sequence and will be recognized as drive C (if any devices are attached).
NOTE:
MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating system
has started.
Shortcut to Temporarily Override Boot Order
To boot one time from a device other than the default device specified in Boot Order, restart the
computer and press F9 when the monitor light turns green. After POST is completed, a list of
bootable devices is displayed. Use the arrow keys to select the preferred bootable device and press
Enter. The computer then boots from the selected non-default device for this one time.
Description
Allows you to set and enable a setup (administrator) password.
See the Desktop Management Guide for more information.
Allows you to set and enable a power-on password. The power-on password prompt appears after
a power cycle. If the user does not enter the correct power-on password, the unit will not boot.
Allows you to enable/disable:
● Lock Legacy Resources (appears if a setup password is set)
●
Network Server Mode (appears if a power-on password is set)
●
Password Prompt on Warm Boot (Ctrl+Alt+Delete) (appears if a power-on password is set)
● Setup Browse Mode (appears if a setup password is set) (allows viewing, but not changing,
the F10 Setup Options without entering setup password)
● Stringent Password (appears if a power-on password is set), which when enabled bypasses
the onboard password jumper to disable the power-on password.
●
Password prompt on F9, F11, & F12 (allows access to menus without entering setup password)
See the Desktop Management Guide for more information.
Computer Setup (F10) Utilities
15