Using Computer Setup (F10) Utilities - HP SignagePlayer mp8000r Maintenance And Service Manual
Maintenance & service guide: hp signageplayer mp8000r and mp8000s
Hide thumbs
Also See for SignagePlayer mp8000r:
- Illustrated parts and service map (4 pages) ,
- Getting started manual (36 pages)
Table of Contents
Advertisement
●
Enable or disable legacy diskette write ability (when supported by hardware).
●
Solve system configuration errors detected but not automatically fixed during the Power-On Self-
Test (POST).
●
Replicate the system setup by saving system configuration information on diskette and restoring it
on one or more computers.
●
Execute self-tests on a specified ATA hard drive (when supported by drive).
●
Enable or disable DriveLock security (when supported by drive).
Using Computer Setup (F10) Utilities
Computer Setup can be accessed only by turning the computer on or restarting the system. To access
the Computer Setup Utilities menu, complete the following steps:
1.
Turn on or restart the computer.
2.
As soon as the computer is turned on, press
Computer Setup. Press
NOTE:
press
3.
Select your language from the list and press Enter.
4.
A choice of five headings appears in the Computer Setup Utilities menu: File, Storage, Security,
Power, and Advanced.
5.
Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and down)
keys to select the option you want, then press Enter. To return to the Computer Setup Utilities
menu, press Esc.
6.
To apply and save changes, select File > Save Changes and Exit.
●
If you have made changes that you do not want applied, select Ignore Changes and
Exit.
●
To reset to factory settings or previously saved default settings (some models), select Apply
Defaults and Exit. This option will restore the original factory system defaults.
CAUTION:
(F10) changes because the CMOS could become corrupted. It is safe to turn off the computer only after
exiting the F10 Setup screen.
Table 3-1
Heading
File
Storage
Security
10
Chapter 3 Computer Setup (F10) Utility
Enter
to bypass the title screen, if necessary.
If you do not press
F10
F10
when the monitor light turns green to access the utility.
Do NOT turn the computer power OFF while the BIOS is saving the Computer Setup
Computer Setup (F10) Utility
F10
when the monitor light turns green to enter
at the appropriate time, you must restart the computer and again
Table
Computer Setup—File on page 11
Computer Setup—Storage on page 12
Computer Setup—Security on page 15
Advertisement
Table of Contents
