Hard Drive - HP SignagePlayer mp8000r Maintenance And Service Manual

Maintenance & service guide: hp signageplayer mp8000r and mp8000s
Hide thumbs Also See for SignagePlayer mp8000r:
Table of Contents

Advertisement

Hard Drive

NOTE:
The Ultra-Slim Desktop supports only 2.5-inch Serial ATA (SATA) internal hard drives; parallel
ATA (PATA) internal hard drives are not supported.
Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you
can transfer the data to the new hard drive.
The 2.5-inch hard drive is enclosed in a carrier under the optical drive.
1.
Prepare the computer for disassembly
2.
If the computer is on a stand, remove the computer from the stand and lay the computer down.
3.
Remove the computer access panel
4.
Remove the optical drive. Refer to
instructions.
5.
Press in the release latch on the left side of the hard drive carrier (1) then rotate the carrier handle
to the right (2).
Figure 7-19
110
Chapter 7 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis
(Preparation for Disassembly on page
(Computer Access Panel on page
Removing the Existing Optical Drive on page 107
Unlocking the Hard Drive Carrier
92).
99).
for

Advertisement

Table of Contents
loading

This manual is also suitable for:

Signageplayer mp8000s

Table of Contents