System Board - HP SignagePlayer mp8000r Maintenance And Service Manual

System Board

CAUTION:
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the optical drive
4. Remove the memory modules
5.
Remove the front fan
6.
Remove the hard drive
7.
Remove the hard drive cage
8.
Remove the front I/O panel cage:
a.
Remove the screw from the right side of the cage that secures the I/O panel cage to the front
of the chassis (1).
b. Press the tab on right side of the cage (2), and then swing the right side of the cage away
from the chassis to remove it (3).
NOTE:
the tab while pressing the tab.
Figure 7-35
9.
Remove the heat sink
10.
Disconnect all cables connected to the system board, noting their location for reinstallation.
Be very careful when removing or replacing the system board to prevent damaging it.
(Removing the Existing Optical Drive on page
(Installing Additional Memory on page
(Front Fan on page
(Hard Drive on page
(Hard Drive Cage on page
If the cage sticks and will not come loose, press down on the top of the panel near
Removing the I/O panel cage
(Heat sink on page
(Preparation for Disassembly on page
(Computer Access Panel on page
116).
110).
114).
119).
92).
99).
107).
102).
System Board
123