Replacing The Optical Drive; Removing The Existing Optical Drive - HP SignagePlayer mp8000r Maintenance And Service Manual
Maintenance & service guide: hp signageplayer mp8000r and mp8000s
Hide thumbs
Also See for SignagePlayer mp8000r:
- Illustrated parts and service map (4 pages) ,
- Getting started manual (36 pages)
Table of Contents
Advertisement
Replacing the Optical Drive
The Ultra-Slim Desktop uses a slimline Serial ATA (SATA) optical drive.
Removing the Existing Optical Drive
1.
Prepare the computer for disassembly
2.
If the computer is on a stand, remove the computer from the stand and lay the computer down.
3.
Remove the computer access panel
4.
Disconnect the cable on the rear of the optical drive (1), push the green release latch on the right
rear side of the drive toward the center of the drive (2), then slide the drive forward and out of the
bay through the front bezel (3).
Figure 7-16
(Preparation for Disassembly on page
(Computer Access Panel on page
Removing the Optical Drive
92).
99).
Replacing the Optical Drive
107
Advertisement
Table of Contents
