Type 3 Battery Holder - HP SignagePlayer mp8000r Maintenance And Service Manual
Maintenance & service guide: hp signageplayer mp8000r and mp8000s
Hide thumbs
Also See for SignagePlayer mp8000r:
- Illustrated parts and service map (4 pages) ,
- Getting started manual (36 pages)
Table of Contents
Advertisement
3.
Replace the computer access panel.
4.
Plug in the computer and turn on power to the computer.
5.
Reset the date and time, your passwords, and any special system setups, using Computer Setup.
Refer to
Type 3 Battery Holder
1.
Pull back on the clip (1) that holds the battery in place, then remove the battery (2).
2.
Insert the new battery and position the clip back in place.
Figure 6-66
3.
Replace the computer access panel.
4.
Plug in the computer and turn on power to the computer.
5.
Reset the date and time, your passwords, and any special system setups, using Computer Setup.
Refer to
90
Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Computer Setup (F10) Utility on page
Removing the battery from a type 3 holder
Computer Setup (F10) Utility on page
9.
9.
Advertisement
Table of Contents
