HP SignagePlayer mp8000r Maintenance And Service Manual page 74
Maintenance & service guide: hp signageplayer mp8000r and mp8000s
Hide thumbs
Also See for SignagePlayer mp8000r:
- Illustrated parts and service map (4 pages) ,
- Getting started manual (36 pages)
Table of Contents
Advertisement
7.
Rotate the drive cage to its upright position.
Figure 6-33
8.
Connect the SATA data cable to the white system board connector labeled SATA1.
9.
Route the data cable through the cable guides.
CAUTION:
drive cage when raising or lowering it. One is located on the bottom side of the drive cage. The
other is located on the chassis frame under the drive cage. Ensure that the data cable is routed
through these guides before connecting it to the optical drive.
10.
Connect the power cable (1) and data cable (2) to the rear of the optical drive.
Figure 6-34
64
Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Rotating the Drive Cage Up
There are two cable guides that keep the data cable from being pinched by the
Connecting the Power and Data Cables
Advertisement
Table of Contents
