Hood Sensor - HP SignagePlayer mp8000r Maintenance And Service Manual

5.
From the outside of the chassis, remove the four Phillips screws that secure the fan to the chassis,
then from the inside of the chassis, slide the fan forward and lift it up and out of the chassis.
Figure 7-37
To install the rear fan, reverse the removal procedure.

Hood Sensor

1. Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Remove the optical drive
4.
Unplug the hood sensor cable from the white system board connector labeled HSENSE and
remove the cable from the white clip mounted on the inside chassis wall.
5. Slide the hood sensor into the chassis to remove it from its slot.
Figure 7-38
To install the hood sensor, reverse the removal procedures.
Removing the rear fan
(Preparation for Disassembly on page
(Computer Access Panel on page
(Removing the Existing Optical Drive on page
Removing the hood sensor
92).
99).
107).
Hood Sensor
125