HP SignagePlayer mp8000r Maintenance And Service Manual page 154

Table C-1 Numeric Codes and Text Messages (continued)
Control panel message
921-Device in PCI Express slot failed to
initialize
1151-Serial Port A Address Conflict Detected
1152-Serial Port B Address Conflict Detected
1155-Serial Port Address Conflict Detected
1720-SMART Hard Drive Detects Imminent
Failure
1796-SATA Cabling Error
1801-Microcode Patch Error
144 Appendix C POST Error Messages
Description
There is an incompatibility/problem with this
device and the system or PCI Express Link
could not be retrained to an x1.
Both external and internal serial ports are
assigned to COM1.
Both external and internal serial ports are
assigned to COM2.
Both external and internal serial ports are
assigned to same IRQ.
Hard drive is about to fail. (Some hard
drives have a hard drive firmware patch that
will fix an erroneous error message.)
One or more SATA devices are improperly
attached. For optimal performance, the
SATA 0 and SATA 1 connectors must be
used before SATA 2 and SATA 3.
Processor is not supported by ROM BIOS.
Recommended action
Try rebooting the system. If the error
reoccurs, the device may not work with this
system
1. Remove any serial port expansion
cards.
2.
Clear CMOS. (See Appendix B,
Password Security and Resetting CMOS
on page 151.)
3. Reconfigure card resources and/or run
Computer Setup.
1.
Remove any serial port expansion
cards.
2.
Clear CMOS. (See Appendix B,
Password Security and Resetting CMOS
on page 151.)
3. Reconfigure card resources and/or run
Computer Setup.
1. Remove any serial port expansion
cards.
2. Clear CMOS. (See Appendix B,
Password Security and Resetting CMOS
on page 151.)
3.
Reconfigure card resources and/or run
Computer Setup.
1.
Determine if hard drive is giving correct
error message. Enter Computer Setup
and run the Drive Protection System test
under Storage > DPS Self-test.
2.
Apply hard drive firmware patch
if applicable. (Available at
http://www.hp.com/support.)
3. Back up contents and replace hard
drive.
Ensure SATA connectors are used in
ascending order. For one device, use SATA
0. For two devices, use SATA 0 and SATA
1. For three devices, use SATA 0, SATA 1,
and SATA 2.
1. Upgrade BIOS to proper version.
2.
Change the processor.