Symantec ALTIRIS OUT OF BAND MANAGEMENT COMPONENT 7.0 SP3 - IMPLEMENTATION GUIDE V1.0 Implementation Manual page 170

170 Troubleshooting Out of Band Management Component
About Intel SCS error messages
Intel SCS error messages
Table A-1
Error
Error 102 - Intel AMT device is
already configured
Error 103 - Request is already in the
queue
Description
Trying to configure an Intel AMT device that is not
in an unconfigured state within the Intel SCS
database.
For example, you configure Intel AMT, and then go
to the MEBx and choose to un-provision
(un-configure) the Intel AMT device. Intel AMT starts
sending Hello messages, but the Intel SCS database
shows that the Intel AMT device was already
configured, so Intel SCS rejects the Hello request.
This error indicates that the Intel SCS database has
the target system that is identified as configured. If
the target system was manually unconfigured
through the local MEBx, then manually delete the
entry from the Intel SCS console.
See "Intel AMT systems page"
From a configuration security perspective, this error
may also indicate an attempt to replay a setup and
configuration sequence. Intel SCS rejects additional
requests if the system is already listed as Configured.
This error can be caused in the following situations:
Trying to delay a request that is already set to be
delayed
Trying to push a request that is already in the
queue
Trying to push a request to the poller that is
already in the poller
This error is a status or an awareness indicator.
Configuration and maintenance requests are queued
within the Intel SCS database and processed by Intel
SCS servers. In larger implementations, multiple
Intel SCS servers can be configured to process
requests within a single Intel SCS database queue.
The queue includes immediate and delayed requests.
Thus, if a request is already delayed, this error is
generated. Similarly, if the request is being processed
or handled by the poller, a competing request
generates this message.
on page 150.