Options on the OOB Site Service page (continued)
Table 10-27
Option
Use TLS for secured
communication
Mutual TLS
authentication
802.1x connections
Server Specific
Installation Settings
Listen Port
Active Directory
integration
Allow Remote
Configuration
About Out of Band Management Component pages
Description
Check if you want the OOB site server installation to verify if
the certification authority is accessible and the site server
can support TLS.
Check if you want the OOB site server installation to verify if
the site server can support TLS mutual authentication.
Check if you want the OOB site server installation to verify if
the site server can support 802.1x connections.
Lets you configure the credentials to use when installing Intel
SCS.
By default, Notification Server application identity credentials
are used to install Intel SCS. If you want, you can specify
another credential.
If Intel SCS is already installed on the computer that you want
to configure, it is reinstalled with the new credentials.
Each instance of Intel SCS listens for Hello messages from
Intel AMT devices on a defined TCP port. Type the TCP port
that you want Intel SCS to use.
The default port is 9971.
The settings under General Intel SCS Settings take effect at
the time of the OOB site server installation. After you installed
an OOB site server, use the General page to configure the
settings.
See
"General page "
on page 142.
Active Directory enables the use of Kerberos authentication,
the Active Directory users list, and 802.1x profiles. Before you
select AD integration, you must integrate Intel SCS with Active
Directory.
See
"Integrating Intel SCS with Active Directory"
Intel AMT releases 2.2, 2.6, 3.0, 4.0, and 5.0 support Remote
Configuration. Check to enable Intel SCS to accept Remote
Configuration requests from Intel AMT devices.
See
"Initializing Intel AMT computers using the Remote
Configuration feature"
on page 65.
163
OOB Site Service page
on page 55.
Need help?
Do you have a question about the ALTIRIS OUT OF BAND MANAGEMENT COMPONENT 7.0 SP3 - IMPLEMENTATION GUIDE V1.0 and is the answer not in the manual?