Setup And Configuration Profile: Power Policy Tab - Symantec ALTIRIS OUT OF BAND MANAGEMENT COMPONENT 7.0 SP3 - IMPLEMENTATION GUIDE V1.0 Implementation Manual

Setup and configuration profile: Power Policy tab

Note: An Intel AMT notebook computer that is configured with a wireless profile
offers full Intel AMT management functionality through the wireless connection,
except for setup and configuration. Setup and configuration is possible only when
the computer is connected to the wired network.
Note: If you want to use wireless profiles with 802.1x authentication to configure
notebook computers with Intel AMT, you must enable Active Directory integration.
See "Integrating Intel SCS with Active Directory"
Options on the Wireless profiles tab
Table 10-11
Option
Create new wireless profile
Add
Up/Down
Enable host VPN routing
Allow wireless connection
without profile
Use these settings to determine what is the highest power state when the Intel
AMT devices that are assigned to this profile will be active or will activate from
a sleep state.
About Out of Band Management Component pages
on page 55.
Description
Click to create a new wireless profile.
See "Auxiliary Profiles: Wireless Profiles page"
on page 130.
Add a wireless profile.
Adjust the relative priority of the profile. The profile at
the top of the list has the highest priority and is tried
first by configured wireless Intel AMT devices.
When checked, Intel AMT devices accept management
traffic over a Virtual Private Network connection when
Intel AMT detects that the platform is operating outside
the enterprise network.
Check to allow Wi-Fi connection even without a profile
(using the host s Wi-Fi settings).
Configuration Profiles page
139