Cops; Copspr - Juniper JUNOSE 11.1.X - SYSTEM EVENT LOGGING REFERENCE GUIDE 3-24-2010 Reference Manual

JUNOSe 11.1.x System Event Logging Reference Guide
10G and 5G SRP modules only That there is not enough bandwidth for a particular
Error
board in the system, that connections could not be added in the fabric due to resource
limitations (such as memory), that a board was just removed and the resource will
not be needed when this condition is detected momentarily, or that a connection
cannot be closed or a multicast destination cannot be dropped.
Cannot connect to a particular source or destination address (board may have just
Warning Log
been removed)
A connection that previously could not be closed has now closed; a multicast
Notice Log
destination that previously could not be dropped has now been dropped
Various logs to indicate events and transitions for low level diagnosis
Info
Various logs to indicate events and transitions for low level diagnosis
Debug
None
Filter

cops

Common Open Policy Service (COPS) protocol
Description
None
Emergency
None
Alert
None
Critical
COPS message with bad header, version, length, or client
Error
Unexpected socket event
Warning Log
COPS layer enabled or disabled; socket remotely closed
Notice Log
None
Info
COPS session instantiation or removal; COPS connection or socket creation or
Debug
deletion; keepalive value
None
Filter

copsPr

COPS-PR general log
Description
54
cops